01
Coil voltage and release current
MOTION / INTERFACE REQUIREMENTS
Holding brake
Distinguish holding from dynamic stopping. Vertical or wheel loads require the equipment designer to establish the brake function and verify timing, monitoring and load capacity.
Provide these inputs
02
Holding torque
03
Engagement/release time
04
Power-off or power-on action
Documentation to confirm
Provide the receiving equipment interface, existing part number where available, supplier drawing and operating duty. Confirm mounting, pin assignment, electrical limits and installation before selection.
← All component blocks Send the requirement ↗RELATED COMPONENTS & FUNCTIONAL BLOCKS
Complete the surrounding interfaces.
Review these categories alongside the current component. A related category is not a verified compatible combination; selected model interfaces still need checking.
RELATED EQUIPMENT / PROJECT CONTEXT
Where this component is considered.
Open an equipment configuration to see its component modules. These are application arrangements rather than stocked finished products.
PROJECT / MODULE / COMPONENT
Equipment projects and integration modules
Outdoor automation
Commercial tracked mowing, sweeping and grounds maintenance.
Explore requirements & interfaces ↗Agriculture & field equipment
Farm/ranch UTV transport and field work.
Explore requirements & interfaces ↗Vehicle intelligence
Vehicle electronics, connectivity, diagnostic workflows and fleet services.
Explore requirements & interfaces ↗Vehicle control & by-wire
Driver intent, torque requests, energy coordination and defined actuator interfaces.
Explore requirements & interfaces ↗Battery, BMS & charging
Pack energy, protection, state estimation and a charger matched to the site.
Explore requirements & interfaces ↗Telematics & vehicle networks
CAN acquisition, gateway routing, location and cellular data transport.
Explore requirements & interfaces ↗